Skip to content
Main -> Dating -> Radiocarbon dating - Wikipedia
  • 27.03.2019
  • by Vigami
  • 2 comments

Radiocarbon dating - Wikipedia

Carbon Dating Explained

Radiocarbon 14 C dating is an isotopic or nuclear decay method of inferring age for organic materials. The technique provides a common chronometric time scale of worldwide applicability on a routine basis in the age range from about calender years to between 40, and 50, years. With isotopic enrichment and larger sample sizes, ages up to 75, years have been measured Taylor , Radiocarbon measurements can be obtained on a wide spectrum of carbon-containing samples including charcoal, wood, marine shell, and bone. Using conventional decay or beta counting, sample sizes ranging from about 0.

Animals eat the plants, and ultimately the radiocarbon is distributed throughout the biosphere. The ratio of 14 C to 12 C is approximately 1. The equation for the radioactive decay of 14 C is: [17]. During its life, a plant or animal is in equilibrium with its surroundings by exchanging carbon either with the atmosphere, or through its diet.

It will therefore have the same proportion of 14 C as the atmosphere, or in the case of marine animals or plants, with the ocean. Once it dies, it ceases to acquire 14 Cbut the 14 C within its biological material at that time will continue to decay, and so the ratio of 14 C to 12 C in its remains will gradually decrease.

The equation governing the decay of a radioactive isotope is: [5]. Measurement of Nthe number of 14 C atoms currently in the sample, allows the calculation of tthe age of the sample, using the equation above. The above calculations make several assumptions, such as that the level of 14 C in the atmosphere has remained constant over time.

Calculating radiocarbon ages also requires the value of the half-life for 14 C. Radiocarbon ages are still calculated using this half-life, and are known as "Conventional Radiocarbon Age". Since the calibration curve IntCal also reports past atmospheric 14 C concentration using this conventional age, any conventional ages calibrated against the IntCal curve will produce a correct calibrated age. When a date is quoted, the reader should be aware that if it is an uncalibrated date a term used for dates given in radiocarbon years it may differ substantially from the best estimate of the actual calendar date, both because it uses the wrong value for the half-life of 14 Cand because no correction calibration has been applied for the historical variation of 14 C in the atmosphere over time.

Carbon is distributed throughout the atmosphere, the biosphere, and the oceans; these are referred to collectively as the carbon exchange reservoir, [32] and each component is also referred to individually as a carbon exchange reservoir. The different elements of the carbon exchange reservoir vary in how much carbon they store, and in how long it takes for the 14 C generated by cosmic rays to fully mix with them.

This affects the ratio of 14 C to 12 C in the different reservoirs, and hence the radiocarbon ages of samples that originated in each reservoir. There are several other possible sources of error that need to be considered. The errors are of four general types:.

To verify the accuracy of the method, several artefacts that were datable by other techniques were tested; the results of the testing were in reasonable agreement with the true ages of the objects. Over time, however, discrepancies began to appear between the known chronology for the oldest Egyptian dynasties and the radiocarbon dates of Egyptian artefacts.

The question was resolved by the study of tree rings : [38] [39] [40] comparison of overlapping series of tree rings allowed the construction of a continuous sequence of tree-ring data that spanned 8, years. Coal and oil began to be burned in large quantities during the 19th century. Dating an object from the early 20th century hence gives an apparent date older than the true date. For the same reason, 14 C concentrations in the neighbourhood of large cities are lower than the atmospheric average.

This fossil fuel effect also known as the Suess effect, after Hans Suess, who first reported it in would only amount to a reduction of 0.

How has radiocarbon dating changed archaeology?

A much larger effect comes from above-ground nuclear testing, which released large numbers of neutrons and created 14 C. From about untilwhen atmospheric nuclear testing was banned, it is estimated that several tonnes of 14 C were created. The level has since dropped, as this bomb pulse or "bomb carbon" as it is sometimes called percolates into the rest of the reservoir. Photosynthesis is the primary process by which carbon moves from the atmosphere into living things.

In photosynthetic pathways 12 C is absorbed slightly more easily than 13 Cwhich in turn is more easily absorbed than 14 C. This effect is known as isotopic fractionation. At higher temperatures, CO 2 has poor solubility in water, which means there is less CO 2 available for the photosynthetic reactions. The enrichment of bone 13 C also implies that excreted material is depleted in 13 C relative to the diet.

The carbon exchange between atmospheric CO 2 and carbonate at the ocean surface is also subject to fractionation, with 14 C in the atmosphere more likely than 12 C to dissolve in the ocean.

This increase in 14 C concentration almost exactly cancels out the decrease caused by the upwelling of water containing old, and hence 14 C depleted, carbon from the deep ocean, so that direct measurements of 14 C radiation are similar to measurements for the rest of the biosphere.

Correcting for isotopic fractionation, as is done for all radiocarbon dates to allow comparison between results from different parts of the biosphere, gives an apparent age of about years for ocean surface water.

The CO 2 in the atmosphere transfers to the ocean by dissolving in the surface water as carbonate and bicarbonate ions; at the same time the carbonate ions in the water are returning to the air as CO 2.

The deepest parts of the ocean mix very slowly with the surface waters, and the mixing is uneven. The main mechanism that brings deep water to the surface is upwelling, which is more common in regions closer to the equator.

Upwelling is also influenced by factors such as the topography of the local ocean bottom and coastlines, the climate, and wind patterns. Overall, the mixing of deep and surface waters takes far longer than the mixing of atmospheric CO 2 with the surface waters, and as a result water from some deep ocean areas has an apparent radiocarbon age of several thousand years.

Upwelling mixes this "old" water with the surface water, giving the surface water an apparent age of about several hundred years after correcting for fractionation.

The northern and southern hemispheres have atmospheric circulation systems that are sufficiently independent of each other that there is a noticeable time lag in mixing between the two. Since the surface ocean is depleted in 14 C because of the marine effect, 14 C is removed from the southern atmosphere more quickly than in the north.

For example, rivers that pass over limestonewhich is mostly composed of calcium carbonatewill acquire carbonate ions. Similarly, groundwater can contain carbon derived from the rocks through which it has passed. Volcanic eruptions eject large amounts of carbon into the air. Dormant volcanoes can also emit aged carbon. Any addition of carbon to a sample of a different age will cause the measured date to be inaccurate.

Contamination with modern carbon causes a sample to appear to be younger than it really is: the effect is greater for older samples. Samples for dating need to be converted into a form suitable for measuring the 14 C content; this can mean conversion to gaseous, liquid, or solid form, depending on the measurement technique to be used. Before this can be done, the sample must be treated to remove any contamination and any unwanted constituents.

Particularly for older samples, it may be useful to enrich the amount of 14 C in the sample before testing. This can be done with a thermal diffusion column. Once contamination has been removed, samples must be converted to a form suitable for the measuring technology to be used.

For accelerator mass spectrometrysolid graphite targets are the most common, although gaseous CO 2 can also be used.

In recent years, scientists have refined methods for radiocarbon dating. Accelerated mass spectrometry, or AMS, is more precise than standard radiocarbon. Prior to the development of radiocarbon dating, it was difficult to tell when an archaeological artifact came from. Unless something was obviously attributable to a. Radiocarbon dating lab scientists and archaeologists should coordinate on sampling, storage and other concerns to obtain a meaningful result.

The quantity of material needed for testing depends on the sample type and the technology being used. There are two types of testing technology: detectors that record radioactivity, known as beta counters, and accelerator mass spectrometers.

For beta counters, a sample weighing at least 10 grams 0. For decades after Libby performed the first radiocarbon dating experiments, the only way to measure the 14 C in a sample was to detect the radioactive decay of individual carbon atoms. Libby's first detector was a Geiger counter of his own design. He converted the carbon in his sample to lamp black soot and coated the inner surface of a cylinder with it.

This cylinder was inserted into the counter in such a way that the counting wire was inside the sample cylinder, in order that there should be no material between the sample and the wire.

Carbon-14 dating decontaminated dinosaur bones

Libby's method was soon superseded by gas proportional counterswhich were less affected by bomb carbon the additional 14 C created by nuclear weapons testing. These counters record bursts of ionization caused by the beta particles emitted by the decaying 14 C atoms; the bursts are proportional to the energy of the particle, so other sources of ionization, such as background radiation, can be identified and ignored.

The counters are surrounded by lead or steel shielding, to eliminate background radiation and to reduce the incidence of cosmic rays. In addition, anticoincidence detectors are used; these record events outside the counter, and any event recorded simultaneously both inside and outside the counter is regarded as an extraneous event and ignored.

The other common technology used for measuring 14 C activity is liquid scintillation counting, which was invented inbut which had to wait until the early s, when efficient methods of benzene synthesis were developed, to become competitive with gas counting; after liquid counters became the more common technology choice for newly constructed dating laboratories.

The counters work by detecting flashes of light caused by the beta particles emitted by 14 C as they interact with a fluorescing agent added to the benzene.

C14 dating archaeology

Like gas counters, liquid scintillation counters require shielding and anticoincidence counters. For both the gas proportional counter and liquid scintillation counter, what is measured is the number of beta particles detected in a given time period.

This provides a value for the background radiation, which must be subtracted from the measured activity of the sample being dated to get the activity attributable solely to that sample's 14 C.

In addition, a sample with a standard activity is measured, to provide a baseline for comparison. The ions are accelerated and passed through a stripper, which removes several electrons so that the ions emerge with a positive charge.

A particle detector then records the number of ions detected in the 14 C stream, but since the volume of 12 C and 13 Cneeded for calibration is too great for individual ion detection, counts are determined by measuring the electric current created in a Faraday cup.

Any 14 C signal from the machine background blank is likely to be caused either by beams of ions that have not followed the expected path inside the detector, or by carbon hydrides such as 12 CH 2 or 13 CH. A 14 C signal from the process blank measures the amount of contamination introduced during the preparation of the sample. These measurements are used in the subsequent calculation of the age of the sample.

The calculations to be performed on the measurements taken depend on the technology used, since beta counters measure the sample's radioactivity whereas AMS determines the ratio of the three different carbon isotopes in the sample. To determine the age of a sample whose activity has been measured by beta counting, the ratio of its activity to the activity of the standard must be found.

To determine this, a blank sample of old, or dead, carbon is measured, and a sample of known activity is measured. The additional samples allow errors such as background radiation and systematic errors in the laboratory setup to be detected and corrected for. The results from AMS testing are in the form of ratios of 12 C13 Cand 14 Cwhich are used to calculate Fm, the "fraction modern".

Both beta counting and AMS results have to be corrected for fractionation. The calculation uses 8, the mean-life derived from Libby's half-life of 5, years, not 8, the mean-life derived from the more accurate modern value of 5, years. Libby's value for the half-life is used to maintain consistency with early radiocarbon testing results; calibration curves include a correction for this, so the accuracy of final reported calendar ages is assured.

The reliability of the results can be improved by lengthening the testing time. Radiocarbon dating is generally limited to dating samples no more than 50, years old, as samples older than that have insufficient 14 C to be measurable.

Older dates have been obtained by using special sample preparation techniques, large samples, and very long measurement times.

These techniques can allow measurement of dates up to 60, and in some cases up to 75, years before the present. Acknowledgments The preparation of this entry was, in part, supported by the Gabrielle O. Bronk Ramsey, C. Radiocarbon dating: revolutions in understanding. Archaeometry Google Scholar. Clark, G.

“Archaeology has the ability to open unimaginable vistas of thousands, even millions, of years of past human experience.” – Colin Renfrew. When it comes to . For nearly 70 years, archaeologists have been measuring carbon levels to date sites and artifacts. Radiocarbon (14C) dating is an isotopic or nuclear decay method of inferring age for organic materials. Radiocarbon measurements can be obtained on a wide spectrum of carbon-containing samples including charcoal, wood, marine shell, and bone. The natural radioactive isotope of.

Aspects of prehistory. Berkeley: University of California Press. Clark, J. Radiocarbon dating and African archaeology, in R. Suess ed. Radiocarbon dating. Cook, G. Radiocarbon as a tracer in the global carbon cycle, in K.

Froehlich ed. Environmental radionuclides: tracer and timers of terrestrial processes, Volume radioactivity in the environment. Amsterdam: Elsevier. Currie, L. The remarkable metrological history of radiocarbon dating. Johnson, F. Rainey, D.

Radiocarbon dating: a summary. Memoirs of the Society for American Archaeology 8: Pollard, A. Measuring the passage of time: achievements and challenges in archaeological dating, in B.

This paper is an overview of recent developments in the radiocarbon dating of the paleoclimatology), archaeology has exploited the possibilities of the method. Since its development by Willard Libby in the s, radiocarbon (14C) dating has become one of the most essential tools in archaeology. Radiocarbon dating . Radiocarbon dating enable archaeologists to provide proof of authenticity to the excavated artifacts' period of usage and thus by collaborating.

Cunliffe, C. Joyce ed. The Oxford handbook of archaeology : Oxford: Oxford University Press. Reimer, P. Baillie, E. Bard, A. Every 5, years, the radioactivity of carbon decays by half. That half-life is critical to radiocarbon dating. The less radioactivity a carbon isotope emits, the older it is. But the amount of carbon in tree rings with known ages can help scientists correct for those fluctuations.

Radiocarbon dating

To date an object, researchers use mass spectrometers or other instruments to determine the ratio of carbon and carbon The result is then calibrated and presented along with a margin of error. Discover other archaeological methods used to date sites. Chemist Willard Libby first realized that carbon could act like a clock in the s.

He won the Nobel Prize in Chemistry for coming up with the method. The method has limitations: Samples can be contaminated by other carbon-containing materials, like the soil that surrounds some bones or labels that contain animal-based glue.

Vudosar

2 thoughts on “Radiocarbon dating - Wikipedia

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top